VTech Telecommunications Ltd 80-6879-01 Manuel D’Utilisation

8

Getting started

Telephone base installation

If you subscribe to high-speed Internet service (DSL - digital subscriber line) 
through your telephone line(s), you must install a DSL filter between each 

telephone line cord and telephone wall jack. The filter prevents noise and 
caller ID problems caused by DSL interference. Please contact your DSL service 

provider for more information about DSL filters.
Option 1: If you have a 2-line wall jack, install the telephone base, as  
shown below.

A DSL filter (not included) 
is required if you have 
DSL high-speed Internet 
service.

Black telephone line cord

Plug the small end of 

the AC power adapter 
into the power jack 
at the bottom of the 
telephone base.

Plug the large end 
of the AC power 
adapter into a power 
outlet not controlled 
by a wall switch.

Plug one end of the 
black telephone line 
cord into the  
LINE 1/L1+L2 
telephone jack at 
the bottom of the 
telephone base. 

Raise the antenna.

Plug the other end of the 
black telephone line cord 
into the DSL filter  
(if required).

Plug the other end 
of the coiled handset 
cord into the jack at 
the bottom of the 
telephone base.

2-line telephone 
wall jack

Use a 4-conductor 

telephone line cord (not 
included) to connect the 

DSL filter and the 2-line 

telephone wall jack.

Route the telephone line 
cord through this slot.

Route the power 
adapter cord 
through this slot.