VTech Telecommunications Ltd 80-6879-01 Manuel D’Utilisation

9

Getting started

Telephone base installation

Option 2: If you have separate wall jacks for each line, install the telephone 
base, as shown below.

DSL filters (not included) 

are required if you have DSL 

high-speed Internet service.

Black telephone line cord

Route the power 
adapter cord 
through this groove.

Plug the small end of the AC power 
adapter into the power jack at the 

bottom of the telephone base and 
route the cord through the slots.

Plug the large end 

of the AC power 
adapter into a power 
outlet not controlled 

by a wall switch.

Plug one end of the 
black telephone line 
cord into the  
LINE 1/L1+L2 

telephone jack at 

the bottom of the 

telephone base.

Raise the antenna.

Plug the other ends of the 

telephone line cords into 
the DSL filters (if required).

Plug the other end 
of the coiled handset 
cord into the jack at 
the bottom of the 

telephone base.

Line 2 telephone 

wall jack

NOTE: This telephone provides minimal functionality during a power outage. When AC power 

is not available, many telephone features do not function. The telephone uses power from 
the telephone line to enable you to make and answer calls using only the corded handset 
and dialing keys. However, only line 1 is available in the event of a power failure.

Line 1 telephone 
wall jack

Clear telephone 

line cord

Use telephone line cords 
(not included) to connect 

the DSL filters and line 1/ 
line 2 telephone wall jack.

Plug one end of the 

clear telephone line 
cord into the  
LINE 2 telephone jack 
at the bottom of the 
telephone base. 

Route the clear 

telephone line cord 

through this slot.

Route the black 
telephone line cord 
through this slot.