VTech Telecommunications Ltd 80-9090-00 Manuel D’Utilisation

13

Getting started

Battery installation and charging

Install the battery as shown below. Once you have installed the battery, the 
screen indicates the battery status (see table below). For best performance, 
keep the cordless handset in charger when not in use. The battery is fully 
charged after 11 hours of continuous charging. See the table in the Technical 
specifications section on page 155 for battery operating times.

The screen is blank or 
shows Place in charger 
and   flashes.

The battery has no or 
very little charge. The 
handset cannot be used.

Charge without interruption (at least 30 
minutes).

The screen shows  
Low battery and   
flashes.

Battery has enough 
charge to be used for a 
short time.

Charge without interruption (at least 30 
minutes).

The screen shows  
HANDSET X.

Battery is charged.

To keep the battery charged, place it in 
charger when not in use.

Step 1
Plug the battery connector 
securely into the socket 
inside the handset battery 
compartment. Insert the 
supplied battery with the 
label THIS SIDE UP facing 
up as indicated.

Step 2
Align the cover flat 
against the battery 
compartment, and then 
slide it upwards until it 
clicks into place.

Use only the supplied rechargeable battery or replacement battery (model BT184342/

BT284342). To order, visit our website at 

 or call  

. In Canada, dial 

. 

If you do not use the handset for a long time, disconnect and remove the battery to prevent 
possible leakage.

•

•

Step 3
Charge the cordless handset by placing it face forward in 
the charger. The CHARGE light on the top of the handset 
is on during charging.

CHARGE light