DEI Headquarters Inc. DEI7352 Manuel D’Utilisation
24
© 2011 Directed Electronics. All rights reserved.
Disarming without a transmitter
If your remote transmitter is lost or damaged, you can manually disarm
your vehicle security system. To disarm the system without a transmitter,
you must have the vehicle’s ignition key and know where the Valet
switch is located. Be sure to check with your installer at the time of
installation for both the location and the preset response (1-5 presses)
of the Valet switch.
your vehicle security system. To disarm the system without a transmitter,
you must have the vehicle’s ignition key and know where the Valet
switch is located. Be sure to check with your installer at the time of
installation for both the location and the preset response (1-5 presses)
of the Valet switch.
To disarm the security system:
1. Turn the ignition to the ON position.
2. Press the Valet button the preset number of times (one to fve times)
2. Press the Valet button the preset number of times (one to fve times)
within15 seconds.
After fve seconds, the sys tem will disarm. If the system does not
disarm, you may have waited too long. Start over by turning the
ignition off and on.
After fve seconds, the sys tem will disarm. If the system does not
disarm, you may have waited too long. Start over by turning the
ignition off and on.
Location of Valet Button_________________________________
Number of Presses_____________________________________
Number of Presses_____________________________________
Important:
The Valet button can be programmed to
respond to 1-5 presses for the disarm function. You
must check with the installer to verify the programming
for your individual unit.
must check with the installer to verify the programming
for your individual unit.