DEI Headquarters Inc. NAH6602 Manuel D’Utilisation
User Guide
P. 15
•
Start the engine by remote.
•
Turn the ignition key to the IGNITION ON (RUN) position.
•
Through advance function remote’s menu (page-6), select L-01.
Press and hold the button until the
icon will disappear on the display.
To verify whether the system is in cold weather mode:
The
icon should appear on your remote display.
OR
Press the brake pedal:
If the vehicle is in cold weather mode, the parking lights will remain ON while the brake pedal
is pressed. (Automatic transmission ONLY)
Press the brake pedal:
If the vehicle is in cold weather mode, the parking lights will remain ON while the brake pedal
is pressed. (Automatic transmission ONLY)
Extended Run Time
While the vehicle is running under a remote start, press and hold the button for more than
3 seconds until the remote beeps 3 times. This will reset the run time counter to zero and restart
the run time cycle from the beginning. The extended run time procedure can only be carried out
once per remote start.
To stop the vehicle, at any moment, simply press the button.
Example: If your remote car starter is programmed for a run time of 3 minutes and your vehicle
3 seconds until the remote beeps 3 times. This will reset the run time counter to zero and restart
the run time cycle from the beginning. The extended run time procedure can only be carried out
once per remote start.
To stop the vehicle, at any moment, simply press the button.
Example: If your remote car starter is programmed for a run time of 3 minutes and your vehicle
has been running for 2 minutes already, pressing the button will reset the counter
to zero and allow the engine to run for another cycle (in this case, 3 minutes).
to zero and allow the engine to run for another cycle (in this case, 3 minutes).
Intrusion Codes via LED light
The system monitors the following:
•
Any vibrations sensed by the shock sensor such as someone breaking of the window,
windshield, etc.
windshield, etc.
•
Doors
•
Ignition
•
Trunk
•
Hood
Note: If an intrusion has occurred the siren will sound for a maximum of 1minute.
When an intrusion has occurred, pressing
will make the siren chirps four times. The antenna’s
LED will provide an intrusion code corresponding to the type of the intrusion that occurred. The
LED intrusion codes are flashed in continuous loops.
2 x = Doors intrusion
LED intrusion codes are flashed in continuous loops.
2 x = Doors intrusion
5x = Panic
3 x = Shock Sense
6x = Ignition
4x = Hood
7x = Trunk
Car Finder™
When enabled, the Car Finder™ option will help you locate your vehicle by sounding a siren or the
horn. To initiate,
horn. To initiate,
1. Through advance function remote’s menu (page-6), select L-01.
2. Press
2. Press
to sound the siren once without affecting the door.