ADC Telecommunications Inc. PSM8019D Manuel D’Utilisation
Page 14
FlexWave Prism Remote Unit RF Module Installation Guide
©2014 TE Connectivity Ltd.
TECP‐77‐141 Issue 6 • 300001744178 Rev F • April 2014
RF Module Cables for Dual‐Bay Installations
For Dual‐Bay installations, the RF cables and connectors are labeled as MOD N TX0/RX0 and MOD N TX1/RX1,
where N refers to the top bay of the double‐bay installation. For example, for a Dual‐Bay installation in a
Quad‐Bay chassis, the RF cables and connectors are labeled as MOD C TX0/RX0 and MOD C TX1/RX1.
The cables and connectors have corresponding labels as shown in
The cables and connectors have corresponding labels as shown in
for Legacy Dual‐Bay 40W
RF Modules.
Table 10.
RF Antenna Labels for Legacy Dual‐Bay 40W RF Modules (From Top of PRU Chassis Down)
RF Module
Cable,
RF Module
Connector, and
Remote Antenna
Connector Label
Function
40W Dual‐Bay Remote Unit RF Module Bay Designations
Dual‐Bay
Tri‐Bay
Tri‐Bay
Quad‐Bay
Bay D
Mod D TX0/RX0
Transmit RF power and
primary/Path 1 receive to/from
the antenna for RF Module D
primary/Path 1 receive to/from
the antenna for RF Module D
N/A
N/A
N/A
MOD C
MOD D
MOD C
Mod D TX1/RX1
Diversity receive/Path 2 for RF
power from the antenna for RF
Module D
power from the antenna for RF
Module D
Bay C
Mod C TX0/RX0
Transmit RF power and
primary/Path 1 receive to/from
the antenna for RF Module C
primary/Path 1 receive to/from
the antenna for RF Module C
N/A
MOD C
MOD C
MOD C
Mod C TX1/RX1
Diversity receive/Path 2 for RF
power from the antenna for RF
Module C
power from the antenna for RF
Module C
Bay B
Mod B TX0/RX0
Transmit RF power and
primary/Path 1receive to/from
the antenna for RF Module B
primary/Path 1receive to/from
the antenna for RF Module B
MOD B
MOD B
MOD B
MOD B
MOD B
Mod B TX1/RX1
Diversity receive/Path 2 for RF
power from the antenna for RF
Module B
power from the antenna for RF
Module B
Bay A
Mod A TX0/RX0
Transmit RF power and
primary/Path 1 receive to/from
the antenna for RF Module A
primary/Path 1 receive to/from
the antenna for RF Module A
MOD A
MOD A
Mod A TX1/RX1
Diversity receive/Path 2 for RF
power from the antenna for RF
Module A
power from the antenna for RF
Module A
Note:For Dual Module installations the center module shelf needs to be removed; see
Note:Install the Legacy Dual-Bay 40W RF Module in the lower-most bay in the chassis. If, however, if two Legacy Dual-Bay 40W RF
Modules are present, install the 2100 Module in the lower-most Bay and the 1900 Module in the upper-most Bay.
Modules are present, install the 2100 Module in the lower-most Bay and the 1900 Module in the upper-most Bay.