TransCore 05716 Manuel D’Utilisation

#8110 – turn on RF port0, send the command on Ctag pin 0, to fire off Ctag address 0.

#8111 – turn on RF port1, send the command on Ctag pin 0, to fire off Ctag address 1.

#8142X – send the command on Ctag pin 0 to set the Ctag character.

#8150 – send the command on Ctag pin 0 to set the Ctag address to 0.

#8151 – send the command on Ctag pin 0 to set the Ctag address to 1.

#8112 – turn on RF port2, send the command on Ctag pin 1, to fire off Ctag address 0.

#8113 – turn on RF port3, send the command on Ctag pin 1, to fire off Ctag address 1.

#8143X – send the command on Ctag pin 1 to set the Ctag character.

#8152 – send the command on Ctag pin 1 to set the Ctag address to 0.

#8153 – send the command on Ctag pin 1 to set the Ctag address to 1.

#836/#837 – Disable/enable MPRR mode

#850 – RF port 0 only (factory default)

#851 – mux between RF port 0

#852 – mux between RF port 0, 1

#853 – mux between RF port 0, 1, 2

#552 – Display mux setting. This display message will include “MPRR” if MPRR 
mode is enabled (#837).

When MPRR mode is disabled, the reader will continuously step through each port 
that has been enabled with #85X, running through whichever tag protocols are 
enabled on each port, in order. The reader turning RF on will be qualified “RF on by 
sense” setting. Command #6401 is used to turn RF on continuously and bypass the RF 
on by sense. Sense0 is used for all antennas that are enabled, if RF is turned on by 
sense, #641.

When MPRR mode is enabled, you must use Sense0 and Sense1 to turn on RF and 
read tags. Sense0, when shorted to reader signal ground, will enable tag reads on RF 
ports 0 and 1 (if enabled with #851) and Sense1 will enable tag reads on Ports 2 and 3 
(if enabled with #853). For example, if commands #837 and #853 have been entered, 
Sense0 is open, Sense1 shorted, and the reader is in data mode, the reader will attempt 
tag reads toggling between RF ports 2 and 3 only. Smart muxing, ATA tag data sniff-