TransCore 05716 Manuel D’Utilisation
Commands
7-33
8143X
Command #8143X sends the command on Ctag pin 1 to set the Ctag character.
8150
Command #8150 sets the check tag address to 0 on check tag pin 0.
8151
Command #8151 sets the check tag address to 1 on check tag pin 0.
8152
Command #8152 send the command on Ctag pin 1 to set the Ctag address to 0.
8153
Command #8153 send the command on Ctag pin 1 to set the Ctag address to 1.
830 Disable Automatic Periodic RF Status Report (Factory
Default)
Default)
Command #830 is a default set in the factory to disable the automatic periodic RF
status report.
status report.
Reader response:
Done
831 Enable Automatic Periodic RF Status Report
Command #831 enables the automatic periodic RF status report. This function sends
out a periodic RF status report if no other message (a tag read) is sent from the reader
for a period of time. This message is the same message that would be sent in response
to the #527 Display RF Status command. Enabling this function is helpful in some
sites where there may not be much tag activity, and the user wants an automatic way to
ensure the communication channel with the reader is still intact. With this function
enabled, the host system will get a message from the reader at least every three min-
utes.
out a periodic RF status report if no other message (a tag read) is sent from the reader
for a period of time. This message is the same message that would be sent in response
to the #527 Display RF Status command. Enabling this function is helpful in some
sites where there may not be much tag activity, and the user wants an automatic way to
ensure the communication channel with the reader is still intact. With this function
enabled, the host system will get a message from the reader at least every three min-
utes.
Reader response:
Done
836 Disable MPRR Mode
Command #836 disables the MPRR mode.
Reader response:
Done
837 Enable MPRR Mode
Command #837 enables the MPRR mode.