TransCore 05716 Manuel D’Utilisation
D-3
Appendix D
Command Quick Reference
This appendix lists the default configuration settings for the
Multiprotocol Rail Reader (MPRR) and its commands. Commands are
listed both numerically and alphabetically.
Multiprotocol Rail Reader (MPRR) and its commands. Commands are
listed both numerically and alphabetically.
Command Syntax
The command numbers consist of from 2 to 4 hex digits. The letters N or S may follow
a command number. The letter N indicates that part of the command number is vari-
able. The letter S indicates the requirement for an alphanumeric data string that is to
be included immediately following the command number. Hex digits (0–9, A–F) in
either uppercase or lowercase characters may be used in data strings and for hex digits
A–F. For more information see Chapter
a command number. The letter N indicates that part of the command number is vari-
able. The letter S indicates the requirement for an alphanumeric data string that is to
be included immediately following the command number. Hex digits (0–9, A–F) in
either uppercase or lowercase characters may be used in data strings and for hex digits
A–F. For more information see Chapter
lists, in numerical
order, all of the commands available to users.
commands by command name.
Factory Default Settings
Note:
lists the factory default settings for the MPRR.
Table D-1 MPRR Default Configuration Settings
Parameter
Setting
Command
Operating mode
Data
00
Baud rate
9600
1005
Stop bits
1
1010
Parity
None
1020
Time and data appended
Enabled
302
Auxiliary information appended
Disabled
310
Unique ID code criteria
Separation of 1 ID
4100
Valid ID code criteria
Acquisition of 1 ID
4200
Uniqueness time-out
2 minutes
441
Tag translation mode
Disabled
452