TransCore 05716 Manuel D’Utilisation
Commands
7-5
Reader Mode Control — Command Group 0
Group 0 commands control reader mode. The mode determines whether the reader is
transmitting data to or receiving data from a host computer or terminal.
transmitting data to or receiving data from a host computer or terminal.
00 Switch to Data Mode (Factory Default)
Command #00 switches the reader to data mode, which allows the reader to transmit
tag data (ID codes) to the host. The reader enters data mode on power up.
tag data (ID codes) to the host. The reader enters data mode on power up.
While operating in data mode, the reader accepts the following commands:
•
Command #01 Switch to Command Mode
Reader response:
Done
01 Switch to Command Mode
Command #01 switches the reader to command mode, which allows the reader to
accept commands from a host or terminal. While in command mode, the reader turns
RF off and does not acquire tags.
accept commands from a host or terminal. While in command mode, the reader turns
RF off and does not acquire tags.
Reader response:
Done
Communications Port Control — Command
Group 1
Group 1
Group 1 commands configure the parameters used by the MPRR to communicate with
a host computer or terminal. These commands set baud rate, stop bits, parity, and end-
of-line delay.
a host computer or terminal. These commands set baud rate, stop bits, parity, and end-
of-line delay.
100N Select Baud Rate
Command #100N selects the reader baud rate. The factory-default setting is 9600
baud. The N variable specifies the baud rate shown in
baud. The N variable specifies the baud rate shown in
.
Table 7-1 Select Baud Rate Commands
Command
Baud Rate Selected
1002
1200
1003
2400
1004
4800
1005
9600 (factory default)
1006
19.2 K
1007
38.4 K