TransCore 05716 Manuel D’Utilisation
Encompass 4 Reader System Guide
7-14
Done
497 Enable Alternate Group Select
Command #497 enables the alternate group select function that allows the reader to
distinguish tags meeting specific criteria pre-programmed into the tags.
distinguish tags meeting specific criteria pre-programmed into the tags.
Reader response:
Done
Reader Status — Command Group 5
Group 5 commands provide status reports on the parameters and operation of the
reader.
reader.
505 Display Software Version
Command #505 displays the reader model number, software version information, and
assigned serial number.
assigned serial number.
Reader response:
Model E4 Series Ver X.XX SNYYYYYY
where
X.XX
Version number
YYYYYY
Serial number of the unit, skipping the fourth character printed on
the reader product label
the reader product label
506 Display Hardware Configuration Information
Command #506 displays hardware configuration information stored in the reader
memory by the user. Hardware configuration information is empty by default until
you set the information to any 20 character ASCII string desired using command
#696S...S
memory by the user. Hardware configuration information is empty by default until
you set the information to any 20 character ASCII string desired using command
#696S...S
.
Reader response:
An ASCII string from 1 to 20 characters in length
510 Display RF Transceiver FPGA Version
Command #510 displays RF FPGA VER = XX.XX
511 Display RF Transceiver I Filter Chip Version
Command #511 displays FIL IC I VER = XX.XX
512 Display RF Transceiver Q Filter Chip Version
Command #512 displays FIL IC Q VER = XX.XX
513 Display DSP Board Actel Version
Command #513 displays DSP FPGA VER = XX.XX