TransCore 05751 Manuel D’Utilisation
www.transcore.com
© 2010 TC License, Ltd. All rights reserved. TRANSCORE is a registered trademark of TC License, Ltd. All other trademarks listed are the property of their respective owners.
Contents are subject to change. Printed in the U.S.A.
Contents are subject to change. Printed in the U.S.A.
S P E C I F I C A T I O N S
600039-003 08/11
2.
Position the OBU so that it is within 18 inches (46 cm) of the center of the front bumper as shown by the shaded area
in
in
. If your vehicle’s license plate mounting area is more than 18 inches (46 cm) from the center, you may need
to select an alternate location on the bumper to mount the OBU. Contact your tag agency if your vehicle requires an
alternate mounting location for the OBU.
alternate mounting location for the OBU.
3.
Hold the OBU so that the mounting holes are to the top and fasten the OBU to the bumper using the license plate
mounting screws (
mounting screws (
). Install the OBU over the top area of the vehicle’s license plate if your vehicle has a front
license plate. If your state does not require a front license plate, install the OBU in the area where a license plate would
normally be mounted
normally be mounted
.
Figure 2 Placement Over the Upper Area of the License Plate
The license plate should have a 90-degree field-of-view to the overhead antenna as the vehicle approaches the toll
plaza/gantry. If the vehicle bumper limits the field-of-view or if the license plate area is angled downward toward
the pavement, you can use an angled mounting bracket to point the OBU upward to increase the field of view and
improve performance (
plaza/gantry. If the vehicle bumper limits the field-of-view or if the license plate area is angled downward toward
the pavement, you can use an angled mounting bracket to point the OBU upward to increase the field of view and
improve performance (
Figure 3 Examples of OBU Installations
NO UNAUTHORIZED MODIFICATIONS STATEMENT
Caution: This equipment may not be modified, altered, or changed in any way without permission from TransCore, LP. Unauthorized modification may void the equipment
authorization from the FCC and will void the TransCore warranty.
authorization from the FCC and will void the TransCore warranty.
RADIO FREQUENCY INTERFERENCE STATEMENTS
Note: This device complies with Part 15 of the FCC Rules and the Industry Canada Licence-Exempt RSS Standards. Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device.
this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device.
Note: Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes: (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur del’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
suivantes: (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur del’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.