TransCore 05752 Manuel D’Utilisation
www.transcore.com
©2012. TransCore, LP. All rights reserved. TRANSCORE and EGO are registered trademarks and EZGO ANYWHERE is a trademark, and are used under license.
All other trademarks are the property of their respective owners. Contents are subject to change. Printed in the U.S.A.
S P E C I F I C A T I O N S
16-xxx-xx 05/31/13
3.
Peel off the double-faced barrier on the hook-and-loop strips or double-sided tape (
).
Note: When installing the OBU for the first time, leave the OBU in place for at least 24 hours to allow the
adhesive to cure.
Figure 2 Remove Backing to Expose Adhesive
4.
Holding the OBU so that the arrows on the front label point up as shown in
, press the OBU against
the windshield and hold for 10 seconds.
Figure 3 Correct Tag Orientation
5.
To remove an OBU from the windshield, grip the OBU at the top and bottom sides. Gently lift the OBU
away from the windshield on one end until the OBU is free from the windshield. Be careful not to hit the
rearview mirror.
away from the windshield on one end until the OBU is free from the windshield. Be careful not to hit the
rearview mirror.
NO UNAUTHORIZED MODIFICATIONS STATEMENT
Caution: This equipment may not be modified, altered, or changed in any way without permission from TransCore, LP. Unauthorized modification may void the equipment
authorization from the FCC and will void the TransCore warranty.
authorization from the FCC and will void the TransCore warranty.
RADIO FREQUENCY INTERFERENCE STATEMENTS
Note: This device complies with Part 15 of the FCC Rules and the Industry Canada Licence-Exempt RSS Standards. Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device.
this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device.
Note: Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes: (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur del’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
suivantes: (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur del’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
Preliminary