TransCore 05946 Manuel D’Utilisation
Page 2
Installation Instructions
2. Clean and dry the interior windshield surface completely before affixing the Dual Lock strips. The
windshield temperature must be at least 68ºF (20ºC) for optimum bonding.
3. Peel the backing off the Dual Lock strips (Figure 2). Leave both sides of the Dual Lock strips
pressed together to ensure the strips will align between the tag and windshield. Apply the
PocketPass to the windshield using moderate pressure.
Figure 2 –
Note: When installing the PocketPass using Dual Lock strips for the first time, leave it in
place for at least 24 hours to allow the adhesive to cure.
place for at least 24 hours to allow the adhesive to cure.
4. To remove a PocketPass mounted with Dual Lock strips from the windshield, grip the case at the
top and bottom sides. Gently lift the PocketPass away from the windshield on one end until the
tag is free from the windshield.
User Replaceable Batteries
Two AAA batteries are pre-installed in your PocketPass. TransCore recommends Energizer® Advanced
Lithium AAA batteries for use in the PocketPass.
To replace the batteries, remove the tag from the windshield as described in Step 4 on page 2.
To replace the batteries, remove the tag from the windshield as described in Step 4 on page 2.
1. Hold the tag with the LED side facing down. Locate the battery door. Press the indentation
located under the arrow and slide the door in the direction of the arrow to open the door.