TransCore 0596465PT15 Manuel D’Utilisation
Commands
7-21
P1
ECP enabled
P2
data inquiry protocol enabled
Txx
ECP timeout where xx = 01 to FE (hexadecimal)
Timeout (ms) = 50 * xx
If xx = FF timeout disabled
X0
Flow control disabled
X1
Software flow control enabled (factory default)
X2
Hardware flow control enabled
S0
start of message character is #
For example, if factory default settings are assigned, the reader message is:
ECPS P0 TFE X1 S0
which means basic protocol enabled, an ECP timeout of 254 (12,700 ms, 12.7 sec),
software flow control enabled, and start of message character is #.
software flow control enabled, and start of message character is #.
526 Display I/O Status
Command #526 displays the current input/output (I/O) status. The reader message
indicates whether outputs are being controlled externally by the host through com-
mand #620N Output Control or internally through command #621 Predefined Output
Mode. It also displays the current status of two outputs, two inputs, and the selected
output pulse duration that is set by command #67N.
indicates whether outputs are being controlled externally by the host through com-
mand #620N Output Control or internally through command #621 Predefined Output
Mode. It also displays the current status of two outputs, two inputs, and the selected
output pulse duration that is set by command #67N.
Reader response:
IOST C<0 to 1> O<0 to 3> I<0 to 3> D<0 to F>
where
C0
Host controls outputs
C1
Predefined output mode
O0
Both outputs off
O1
Output0 on
O2
Output1 on
O3
Both outputs on
I0
Both inputs false
I1
Input0 true