TransCore 0596465PT15 Manuel D’Utilisation

in all readers. In this example it is determined that an IAG attenuation setting of 6 dB 
(#64606) prevents a reader from activating a tag in an adjacent lane.

1*

#64814 = 20 ms synchronization time

#64901 = 1 ms hold off

2

#64816 = 22 ms synchronization time

#64902 = 2 ms hold off

3

#64818 = 24 ms synchronization time

#64903 = 3 ms hold off

4

#6481A = 26 ms synchronization time

#64904 = 4 ms hold off

5

#6481C = 28 ms synchronization time

#64905 = 5 ms hold off

* Reader 1 becomes the bus synchronization master.

Command #65 resets the power fail bit to 0. The bit changes from 0 to 1 when power 
is restored to the reader. Upon reader power-up, the host transmits either command 
#65

 or #63 Reset Reader to properly initialize this bit. The current state of the power 

fail bit may be displayed. Refer to 

 for 

more information.

Reader response:

Done

Command #66F loads all the factory default operating parameters except RF operat-
ing frequency. Refer to 

tings” 

for a listing of the defaults.

Reader response:

Done

All parameters loaded OK

Error

A parameter load failed

Command #67N sets the output pulse duration for the command #621 Predefined 
Output Control. This command specifies the length of time that output line(s) will be 
asserted upon receipt of a valid and unique tag ID. The factory default setting is 228 
ms. The variable N specifies an output pulse duration of 48 ms to 752 ms.

Uppercase or lowercase characters are allowed for N; for example, hex digits A 
through F or a through f. The command numbers and corresponding output pulse 
durations are shown in