TransCore 0596465PT15 Manuel D’Utilisation

You will need the following materials to install interior tags:

Rubbing alcohol or 50/50 isopropyl alcohol and water

Sponge and dry cloth

Interior tags with two strips of factory-installed hook-and-loop material or fac-

tory-installed double-sided tape attached

Interior ATA-protocol tags can be installed on the driver’s side, passenger’s side, or 
upper center of the vehicle’s windshield, depending on the Encompass 4H Reader’s 
position. See 

Tags should be mounted consistently in all vehicles using a particular Encompass 4H 
Reader facility. 

TransCore designed interior ATA-protocol tags for installation inside the vehicle, typ-
ically on the driver’s side of the windshield. Install the tag in the upper corner, at least 
two inches (5 cm) from the metal window post, as shown in 

Figure 3-19.

You may also install ATA tags on the upper center portion of the windshield. Position 
the tag as closely as possible to the windshield’s upper center, behind the rearview 
mirror. The top edge of the tag should be approximately one inch (2.5 cm) below the 
base of the mirror, or above the base if enough room is available for the tag to be two 
inches (five cm) from metal around the windshield, as shown in 

Figure 3-20.