TransCore 0596465PT15 Manuel D’Utilisation
Encompass 4H Reader System Guide
3-22
Positioning ATA License Plate Tags
The orientation of the tag is important. The tag must be mounted so that the holes on
the tag base plate are on the bottom edge. See
the tag base plate are on the bottom edge. See
.
Figure 3-22 Proper Tag Orientation
When positioning the tag, observe the following guidelines:
•
The tag should be horizontal and parallel to the ground.
•
The tag face should be perpendicular or tilted slightly upward.
•
The tag may lean to the rear a maximum of 30 degrees.
•
The tag may lean to the front a maximum of 10 degrees.
ATA License Plate Tag Installation Procedures
To mount the LPT
1.
1.
Position the tag so that the holes in the tag are on the bottom edge and the tag is
within 18 inches (.45 m) of the center of the front bumper as illustrated by the
shaded area in
within 18 inches (.45 m) of the center of the front bumper as illustrated by the
shaded area in
.
Note: When mounting an exterior tag on heavy trucks or tractors, the tag must
be mounted within 1.5 inches (3.81 cm) of the top of the bumper.
be mounted within 1.5 inches (3.81 cm) of the top of the bumper.