TransCore 2611SS Manuel D’Utilisation
Hardware Interfaces
D-23
Table D-15 RF Module Power
Table D-16 shows the IT2611 RF Module-to-antenna connectors for bistatic operation
and Table D-17 shows the connectors for monostatic operation.
and Table D-17 shows the connectors for monostatic operation.
IT2410 Tag Programmer Hardware Interconnection
The IT2410 Tag Programmer requires only a small DC power supply and a DB-9
serial interface cable. Cabling for the two interconnections requires proper shielding
at both ends to meet Part 15 of FCC emission requirements.
serial interface cable. Cabling for the two interconnections requires proper shielding
at both ends to meet Part 15 of FCC emission requirements.
The serial interface is RS-232 compatible. A null-modem adapter is required to con-
nect the programmer to RS-232 serial interfaces from most computers configured as
data terminal equipment (DTE). No hardware handshaking is employed; however,
handshaking is accomplished by firmware protocol as described in the interface defi-
nitions. Pin-outs of the RS-232 serial interface are shown in Table D-18.
nect the programmer to RS-232 serial interfaces from most computers configured as
data terminal equipment (DTE). No hardware handshaking is employed; however,
handshaking is accomplished by firmware protocol as described in the interface defi-
nitions. Pin-outs of the RS-232 serial interface are shown in Table D-18.
Pin
Description
A
19- to 28-VAC or
16- to 28-VDC
16- to 28-VDC
C
19- to 28 VAC Return or
16- to 28-VDC Return
16- to 28-VDC Return
B
Not connected
Table D-16 RF Module-Antenna Connectors for Bistatic Operation
Connector
Description
Type
J1
RF uplink (receive) antenna
N Socket
J2
RF downlink (transmit)
antenna
antenna
N Socket
J3
Check tag antenna
N Socket
Table D-17 RF Module-Antenna Connectors for Monostatic Operation
Connector
Description
Type
J1
RF uplink/downlink (receive/
transmit) antenna
transmit) antenna
N Socket
J3
Check tag antenna
N Socket