TransCore 2611SS Manuel D’Utilisation
IT2200 Reader System with Multimode Capability Installation & Maintenance/Service Guide
4-6
Canopy Mount
The canopy mount is typically used for covered toll plazas. The reader logic card is
installed in the host computer. The RF module, Universal Toll Antenna(s) (UTA), and
check tag antenna are attached to a 5.0 to 7.6cm (2- to 3-in) pipe that is supported
from the plaza canopy. The pipe is located approximately 4.5 to 5.5 m (15 to 18 ft)
above the road surface and 1.8 m (6 ft) downstream of the collection point. The collec-
tion point is the centerline of the toll booth door, coin basket, or light curtain, depend-
ing on the site configuration. Figure 4-1 illustrates a typical canopy mount.
installed in the host computer. The RF module, Universal Toll Antenna(s) (UTA), and
check tag antenna are attached to a 5.0 to 7.6cm (2- to 3-in) pipe that is supported
from the plaza canopy. The pipe is located approximately 4.5 to 5.5 m (15 to 18 ft)
above the road surface and 1.8 m (6 ft) downstream of the collection point. The collec-
tion point is the centerline of the toll booth door, coin basket, or light curtain, depend-
ing on the site configuration. Figure 4-1 illustrates a typical canopy mount.
Figure 4-1 Canopy Mount