Lotek Wireless Inc SRX400158-170 Manuel D’Utilisation
14
NEW PROM Initializes
Enter access code:
Enter access code:
This access code can be obtained from your LOTEK account representative or one of our systems
engineers if this function is required.
engineers if this function is required.
Again, ESC can be pressed to return to the power-on default display or the access code can be
entered. As the access code is entered, random characters appear on the display. When the
correct code has been accepted, the receiver will display the following:
entered. As the access code is entered, random characters appear on the display. When the
correct code has been accepted, the receiver will display the following:
NEW PROM: Purge tables
and storage? 1)Y 2)N
and storage? 1)Y 2)N
At this point, the ESC abort option is still supported, however, if 1 is pressed, all frequency
tables will be purged. It will be necessary to reprogram the frequency tables before scanning can
resume. If 2 is pressed, the frequency tables will remain intact. In either case, the following
display appears:
tables will be purged. It will be necessary to reprogram the frequency tables before scanning can
resume. If 2 is pressed, the frequency tables will remain intact. In either case, the following
display appears:
Program frequency range?
1)Yes 2)No
1)Yes 2)No
If 2 is pressed, the receiver will retain the current values for the receiver base frequency, local
oscillator frequency and IF frequency and continue to the port configuration display shown
below. Otherwise, if 1 is pressed the following appears:
oscillator frequency and IF frequency and continue to the port configuration display shown
below. Otherwise, if 1 is pressed the following appears:
Enter start frequency
>
>
At this point, you will have to remove the bottom cover of the Suretrack receiver to see the
calibration information recorded on a sticker. The start frequency should be entered as shown,
this time using the "." key before the last three digits. If the last three digits are 0, they, or the
decimal are not needed. If you make a mistake, the downward arrow can be used to erase the
last digit. After the start frequency is keyed in, press the upward arrow key to enter it. If ESC is
pressed, the old value will be retained. After this, the following display appears:
calibration information recorded on a sticker. The start frequency should be entered as shown,
this time using the "." key before the last three digits. If the last three digits are 0, they, or the
decimal are not needed. If you make a mistake, the downward arrow can be used to erase the
last digit. After the start frequency is keyed in, press the upward arrow key to enter it. If ESC is
pressed, the old value will be retained. After this, the following display appears:
Enter LO frequency
>
>
Now, enter the IF frequency shown on the sticker in the same manner as the start frequency.
Next, the following display appears:
Next, the following display appears:
Enter IF frequency
>
>
Enter the LO frequency shown on the label. After this is entered, the display shows briefly:
148-152MHz
Synth count = 21297
Synth count = 21297
Then the following is briefly displayed:
Port configured:
4800,N,8,1
4800,N,8,1