Thomson 2-5110A Manuel D’Utilisation
33
memory and Caller ID memory for up to 5 minutes.
Headset Battery
1. Make sure the telephone is
OFF (not in TALK mode) before you replace battery.
2.
Remove the foam cover and open the battery compartment door on the head-
set.
3. Disconnect the cord attached to the battery pack from the jack inside the bat-
tery compartment and remove the battery pack.
4. Insert the new battery pack and connect the plug on the battery pack to the
jack inside the compartment.
NOTE: It is important to maintain the polarity (black and red wires) to the jack inside the
compartment. To ensure proper battery installation, the connector is keyed and can be
inserted only one way.
inserted only one way.
5.
Close the battery compartment by snaping the cover into place.
6. Place the
headset
in the charging cradle.
Allow the
headset
battery to properly charge (for 16 hours) prior to first use or when you
install a new battery pack. If you do not properly charge the phone, battery performance
will be compromised.
CAUTION: To reduce the risk of fire or personal injury, only use ATLINKS Li-polymer battery
model 5-2682.
model 5-2682.
Battery Safety Precautions
• Do not burn, disassemble, mutilate, or puncture. Like other batteries of this type,
toxic materials could be released which can cause injury.
• To reduce the risk of fire or personal injury, use only the battery listed in the
User’s Guide.
• Keep batteries out of the reach of children.
Other Information