Tekk XT100 Manuel D’Utilisation
XT-Series Tekk Portable LMR radio
- Function description
1. power on& volume control
(1) Power On
Turn radio on by turning the power/volume Rotary switch
clockwise out of detent. When radio turns on, it make beep
sound.
clockwise out of detent. When radio turns on, it make beep
sound.
(2) Power Off
Turning the power /volume rotary switch counterclockwise out
of detent
(3) Volume up/down
Adjusting level of volume by turning Volume rotary switch.
2. Channel Selecting (Up/Down)
User can choose a channel by adjusting Channel rotary switch
3. RX Operation
1) Busy condition is that unit is receiving a signal fixed in its channel
Unit in the busy condition will be operated according to a fixed input
of tone and two Tone. Unit out of busy condition will remain LED Off
of tone and two Tone. Unit out of busy condition will remain LED Off
2) Correct Call
If a incoming signal has same tone as a fixed input of tone in
selected channel,
This signal is called “Correct Unit will open Audio with Green LED, If
a incoming signal is not correct call, LED will be On in orange.
selected channel,
This signal is called “Correct Unit will open Audio with Green LED, If
a incoming signal is not correct call, LED will be On in orange.
3) Monitor Operation
Whenever Monitor button is pressed, Audio must be opened
regardless of the condition of busy or correct call.
- Monitor On : press Monitor button in left side of radio, Audio will be
opened.
regardless of the condition of busy or correct call.
- Monitor On : press Monitor button in left side of radio, Audio will be
opened.
If press Monitor button for five seconds, Monitor button will be
locked and then a opened audio will be maintained, even
though user release monitor button. If user release monitor
button within five seconds, Monitor function will be Off and then
Audio will be controlled by a incoming signal.
locked and then a opened audio will be maintained, even
though user release monitor button. If user release monitor
button within five seconds, Monitor function will be Off and then
Audio will be controlled by a incoming signal.
To be out of Monitor condition, Just press monitor again.
4) Scan operation
- Normal scan On : Press Sacn Button on the left side of radio for two
seconds,
User can initiate scan with beep sound. If no conversation is detected
- Normal scan On : Press Sacn Button on the left side of radio for two
seconds,
User can initiate scan with beep sound. If no conversation is detected
on any channel in the scan list, Radio will make Error beep sound,