Tekk XT100 用户手册

 

 

(1) Power On 

Turn radio on by turning the power/volume Rotary switch 
clockwise out of detent. When radio turns on, it make beep 
sound. 

(2) Power Off 

Turning the power /volume rotary switch counterclockwise out 

of detent 

(3) Volume up/down 

 Adjusting level of volume by turning Volume rotary switch. 

User can choose a channel by adjusting Channel rotary switch 

          
    3.  RX Operation 

1)  Busy condition is that unit is receiving a signal fixed in its channel 

Unit in the busy condition will be operated according to a fixed input 
of tone and two Tone. Unit out of busy condition will remain LED Off 

2)  Correct Call 

If a incoming signal has same tone as a fixed input of tone in 
selected channel, 
This signal is called “Correct Unit will open Audio with Green LED, If 
a incoming signal is not correct call, LED will be On in orange. 

3)  Monitor Operation 

Whenever Monitor button is pressed, Audio must be opened 
regardless of the condition of busy or correct call. 
 
- Monitor On : press Monitor button in left side of radio, Audio will be 
opened. 

If press Monitor button for five seconds, Monitor button will be 
locked and then a opened audio will be maintained, even 
though user release monitor button. If user release monitor 
button within five seconds, Monitor function will be Off and then 
Audio will be controlled by a incoming signal. 

To be out of Monitor condition, Just press monitor again. 

     4) Scan operation 
       - Normal scan On : Press Sacn Button on the left side of radio for two 
seconds, 
         User can initiate scan with beep sound. If no conversation is detected 

on any channel in the scan list, Radio will make Error beep sound,