Advance Security Inc T36 Manuel D’Utilisation

 

Spin up the   switch

 

To the page 6

Press the button 3 and the setting is 

done also the “TX 3” will display on 

the OLED screen 

This security system is equipped with circuitry that will allow the unit to remember its alarm state if the 
power is lost and then reconnected.   
 

REMOTE START OPERATION 

 

1. Press 

  button twice on the transmitter. 

2. The parking light will activate to indicate the remote start received the signal. (A 

melody sounding from your Remote OLED transceiver and 

“

” 

icon will flashes on 

the OLED screen to confirm the remote start was activated.) 

3. The engine will start approximately 5 seconds. 
4. Once the engine is running, after couple seconds the parking light will turn on 
again  
  and climate controls will activate and adjust the vehicles interior temperature to 
your 
  Preset setting. (While the vehicle is running, the “Engine Running” icon and the 

“minutes” digit on the OLED screen will flash and it will indicate count down timer 
based on the 5, 10, 20 or 30 minute run time set up by your installation center.) 

5. The vehicle will run for 5 to 30 minute cycle and automatically shut down. (When 

the unit shuts off the count down timer will turn off and the transmitter will play a 
melody.) 

Note: The Remote Start Unit will not start the vehicle if any one of the following 

conditions exists:

 

 

1. The hood is opened. 
2. The brake pedal is pressed. 
3. Move the optional remote start enable toggle switch to OFF position. (If installed) 
4. The gear selector is in any gear other then “PARK” or “NEUTRAL”

To operate the vehicle while engine running on the remote start. 
1. Insert the ignition key and turn it to “ON” (not the start) position. 
2. Press the brake pedal. 
Note: If the brake pedal is pressed before the key is in the ON position, the engine will shut down. 

This feature allows the vehicle to remain running after the key has been removed from the ignition. This 
feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but 
would like to leave the motor running and the climate control on. 
1. Before turning off the engine, press the 

  button twice on the transmitter. 

-- The LED indicator will flash 3 times to confirm enter. 

2.Turn the ignition key to OFF position. (The engine will stay running.) 
3.The engine will run until the pre-programmed time elapsed or shutdown input is received. 

   

Turbo timer mode keeps the engine running after arriving at you destination for a 
programmable period of 3, 5 or 10 minutes, This allows the system’s time to 
conveniently cool down the turbo after you have left the vehicle. To activate the turbo 
timer: 
1. While engine is running, place the transmission gear in the park position and pull 

up the hand brake. 

2. Before turning off the engine, Spin up the

   

switch to the page

 5

and then press 

the “Turbo Start” button or press and release 

 and 

  buttons at the same time.

   

-- The parking light will activate to indicate the remote start has entered turbo timer mode. -- 

3. Pull off the “Ignition Key” from the key cylinder.                            

-- Engine keeps running. -- 

4. Exit and secure the vehicle.   

-- Engine continues running until the pre-programmed time elapsed. -- 

If you do not want the vehicle to continue to run for one cycle, simply step on the vehicle's brake, or 
activate the 

  button in succession. Any of these will cause the engine to turn off. 

 

18