HeathCo LLC 62WDB93TX Manuel D’Utilisation
-2-
598-1105-00
2.
Set the push button dip switches to match the chime
receiver code. See "Code and Tune Setting" section.
receiver code. See "Code and Tune Setting" section.
1.
Install two lithium type CR1220 3 volt
push button batteries (included). Re-
move back of case by pushing in tab
on bottom with a small screwdriver.
Make sure batteries are oriented prop-
erly (see page 6).
push button batteries (included). Re-
move back of case by pushing in tab
on bottom with a small screwdriver.
Make sure batteries are oriented prop-
erly (see page 6).
4.
Mount push button.
Remove back of case by pushing in tab
on bottom with a small screwdriver.
Attach back of case to door jamb or wall
with screws provided. Snap front of push
button on.
on bottom with a small screwdriver.
Attach back of case to door jamb or wall
with screws provided. Snap front of push
button on.
3.
Test range. Temporarily position push button where you want
it mounted. Press push button to verify chime and push button
work properly. If chime does not sound, see Troubleshooting.
it mounted. Press push button to verify chime and push button
work properly. If chime does not sound, see Troubleshooting.