HeathCo LLC 62WDB93TX Manuel D’Utilisation

-3-

598-1105-00

Note: Most installations will not require you to change any jump-
ers or dip switch settings on your chime and push button.
WARNING: Disconnect chime unit from power source be-
fore opening code access door. Close door and replace
screw before reconnecting to power.
The push button and chime communicate by using a code that
can be changed by switching dip switch positions (or removing
and/or adding jumpers) on both the push button and chime. The
code is factory set; however, there are 128 selectable codes
that allow you to expand your system and prevent outside inter-
ference. Other wireless products may cause interference and
the system may not function properly. Follow the instructions
below for setting a new code.
1. Unplug wireless chime (if applicable).
2. Open the cases and locate the jumpers or dip switches on

both the push button and chime (See illustration on page 6).

3. The push button and chime both have eight different jumper/

dip switch locations. Positions 1 through 7 are used for set-
ting the code.

4. To change the code, add and/or remove jumpers or change

dip switch setting as needed. It is recommended to only
change one setting at a time and then check to see if system