Tatung Company ROS2000A Manuel D’Utilisation

You can access RadioTime and YouTube without entering account information, but to see 

your favorites and saved channels, you will need to enter your account information. Once 

your account is created, complete the following procedure to validate and save your account 

information (user name and password) on the Home Center. 

NOTE: If you change your user name 

and password on the services web site, 

you must make account changes on the 

Home Center as well.

On your PC, log into the Home Center 

(Media Figure 1). 

Select a media service.

Enter your service user name and 

password and click 

SAVE. The account 

information is validated. If the user name 

and password entered on the Home 

Center do not match those that on the 

service’s web site, an error message 

displays. Re-enter the user name and 

password and click Validate Account 

again. 

Follow the same procedure for each 

media service as needed. Note that 

if you log into any of your services 

web sites and change your user name 

or password, you must re-enter this 

information on the Home Center. 

By default the media access pin to 

restrict content is disabled. To enable 

the media access PIN, select the 

Manage Access tab and check the 

check box (Media Figure 3).

To change the 4 digit media pin used to 

control access to media services, click 

Media Pin and enter four numbers. 

Click 

Save (Media Figure 4). 

sm

Refer to the Remote Control Codes 

starting in the back of this document 

and find your TV or device code (for 

newer televisions, start at the end of the 

list of codes for your brand and work 

backwards). If more than one code is 

available, use the first 4-digit code listed. 

If your device is newer, use the last code 

listed and work backward through the 

list.

Turn on your TV or device that you want 

to use with the TV Extender remote. For 

this procedure, we will use TV as an 

example but this same process will work 

with any supported device.

On the remote, press and hold the

button and the 

OK button (Remote 

Figure 1).

Release both buttons. All four 

MODE 

buttons (

sm

, AUX, TV, and STB) 

blink twice

Enter the 4-digit code for your TV. The 

TV button blinks three times (Remote 

Figure 2). 

To make sure that this is the correct 

code, point the remote at your TV and 

press the 

Power button. If the TV turns 

off, you have successfully programmed 

the remote. If the TV does not turn off, 

repeat this procedure using the next 

code listed for your TV. If you can turn 

the TV on and off, but some of the 

remote buttons do not operate the TV 

as you would expect, try using the next 

code listed for your TV.

NOTE: For more information about your 

remote, see the back of this Install Guide.

Your ROS

sm

 TV Extender remote is automatically programmed to operate the TV Extender. 

You can program this remote to operate up to three additional devices like a DVD player, 

cable or satellite receiver, or television. This procedure describes how to program the 

remote control by entering a specific code for your device. The following steps describe 

how to program the remote for a TV, using the TV button. For other devices such as a cable 

or satellite receiver or DVD player, follow the same steps, but use the STB or AUX button 

instead of the TV button.

To reset your remote: 

Press and hold the ROS

sm

 key. While 

holding down the ROS

sm

 key, press OK. 

Release both keys. The device keys blink 
twice. Press 9 - 0 - 0. The ROS

sm

 key 

blinks three times to indicate that the reset 

was successful.