Tyco Safety Products/Sensormatic AMS9050 Manuel D’Utilisation
Preliminary
AMC-7000 INTEGRATED METAL Foil DETECTION
8200-2609-01, REV. 3a
INSTALLATION GUIDE
29 OF 31
Configuring the Alarm Settings
On the Setup screen, configure the Lamps, Relays,
and Audio settings to the appropriate values for the
and Audio settings to the appropriate values for the
g
rs a
s
M
at
the r
h
a
e relays at P9 on the
Detection Board activate only for metal
for on
d and are not configurable.
site.
Note
: the rel
paramete
controller
controller
ays you confi
re the relay
P54, not
ure with the Relays
in the A
elays on t
S-9050
e Met
l
Detection Bo
Metal
Metal
ard at P9. Th
events
e secon
The detector can be configured to alarm on three
vents: a metal foil detection event, a jammer
etection event, and an EAS tag detection event. It
etection event, and an EAS tag detection event. It
can signify any of these events in three ways:
trigger a relay, flash an alarm lamp, or emit an
audio alarm.
trigger a relay, flash an alarm lamp, or emit an
audio alarm.
The following table shows how to configure the
Relay parameters for what you want; the Audio and
Lamps parameters are configured similarly.
Relay parameters for what you want; the Audio and
Lamps parameters are configured similarly.
Table 1. Configuring relays
Then set the following…
e
d
d
If Relay 1 is
for a ___
event …
for a ___
event …
And Relay 2
is for a ___
event…
is for a ___
event…
Relay
Number
Number
Metal
Event
Event
Jammer
Event
Event
Metal Metal
All
Metal EAS
1
EAS
Metal
2
Jammer Jammer
All
Jammer EAS
1
EAS Jammer 2
Metal and
Jammer
Jammer
Metal and
Jammer
Jammer
All
Metal and
Jammer
Jammer
EAS 1
EAS
Metal and
Jammer
Jammer
2
EAS EAS
All
EAS Not
Used 1
Not Used
EAS
2
Note
: if a customer does not want the audio alarm
to go off for metal foil detection events, set the
Duration and Volume to 0 (zero).
Duration and Volume to 0 (zero).