Tyco Safety Products/Sensormatic AMS9050 Manuel D’Utilisation

Preliminary 

AMC-7000 INTEGRATED METAL Foil DETECTION 

8200-2609-01, REV. 3a 

INSTALLATION GUIDE 

30 OF 31

 

Primary Input: ............................. 12V DC (-4V;+8V) 
Power Req. ..................................................... < 3W 

Contact Form:.................................................DPDT 
Rated Load:............ 0.5A at 125VAC; 1A at 30VDC 
Max. Operating Voltage:............. 125VAC; 110VDC 
Max. Switching Capacity: ................... 62VA or 33W 
Min. Permissible Load ..................... 10μA;10mVDC 

V

inp

 (max):.....................................................120V

o-p

 

I

inp

(max): ............................................... 18A

o-p

;5A

rms

 

Operating Temperature:.. 0° to 50°C (32° to 122°F) 
Non-operating Temperature....-40° to 70°C (-40° to 
158°F) 
Relative Humidity: .......... 0 to 90% non-condensing 
Enclosure Rating ..............................................IPX0 

 

Length............................................ 28.3cm (11 1/8”) 
Width ............................................... 17.5cm (6 7/8”) 
Height ................................................ 8.6cm (3 3/8”) 
Weight ..........................................1.8kg (3bs. 14oz) 

 

EMC ...............................................47 CFR, Part 15 
 

 

Safety.................................................... UL 60950-1 
 

CSA C22.2. 60950-1 

 EN 

60950-1 

 

REGULATORY PRODUCT NAME:  
AMC-7000 = TYPE: AMC-7000 

EQUIPMENT MODIFICATION CAUTION: Equipment 
changes or modifications not expressly approved by 
Sensormatic Electronics Corporation, the party responsible for 
FCC compliance, could void the user's authority to operate the 
equipment and could create a hazardous condition. 

See “Note: There may be installation restrictions on antennas 
in certain countries. See antenna installation guides for 

 

 

r, 

r 

restrictions, if any. 

 This device is

only intended to be installed as described 
in the installation guide. 

-  Because customer requirements dictate the 

placement of system components, your 
Sensormatic representative will supply this 
information separately. 

-  If this product was installed in a European 

Union or European Free Trade Association 
member state, please give the Declaration of 
Conformity included with this product to the 
manager or user. By law, this information must
be provided to the user. 

-  Because of the number of antennas and 

accessories that can connect to this controlle
methodically install this system to avoid 
problems. See “System Setup” in this guide fo
guidance on how to setup antennas.