HM Electronics Inc XCVR2G4A Manuel D’Utilisation
User Guide | FreeSpeak II™
Page 107
A list of available systems appears on the beltpack screen.
3)
Use the rotary control to select a system.
8.13
Enabling over the air (OTA) registration mode
from a beltpack
from a beltpack
In some circumstances you may need to enable registration of beltpacks without
having access to a Base station or computer. In this case it can be done from a
beltpack.
having access to a Base station or computer. In this case it can be done from a
beltpack.
The beltpack needs to be previously registered and connected. You need the
system admin code, available from Eclipse EHX, the Configuration Editor or the
Base station. (The default code is 4632).
system admin code, available from Eclipse EHX, the Configuration Editor or the
Base station. (The default code is 4632).
Note:
The admin code is available on the System tab in the FS II Configuration Editor.
On the Base station go to MENU->SYSTEM->REG->PIN to find this code.
On the Base station go to MENU->SYSTEM->REG->PIN to find this code.
1)
From the registered, connected beltpack press and hold the MENU button
for 2 seconds to enter the menu options.
for 2 seconds to enter the menu options.
2)
Go to SETTINGS -> ADMIN OPTIONS
3)
Enter the admin code using the left and right hand rotary controllers on
the beltpack.
the beltpack.
4)
If the admin code is successful, the beltpack will display the ‘Enable Pair
Mode’ screen.
Mode’ screen.
5)
Press the D key on the beltpack to select this option.
6)
A confirmation screen will appear. Select Y to confirm.
The system will now be open for registration for 2 minutes.
7)
From the beltpack to be registered, follow the registration procedure. See
3.4.1 Over the air (OTA) registration of a beltpack from the Base
station, step 2.
3.4.1 Over the air (OTA) registration of a beltpack from the Base
station, step 2.
8.14
Performing a site survey
Note:
You can only access this option if you have advanced menu access.
You can survey an intercom installation to determine how may FreeSpeak II
antennas are present. You can do this in two ways:
antennas are present. You can do this in two ways:
•
Connecting to a system and detecting all FreeSpeak II antennas
connected to that system
connected to that system