HM Electronics Inc XCVR2G4A Manuel D’Utilisation
User Guide | FreeSpeak II™
Page 71
an auto route from the headset to the chosen destination the key on the Base
station front panel should be used.
station front panel should be used.
7)
From the MAIN menu, select ‘PORTS’. A menu of the available audio ports
is displayed.
is displayed.
Figure 6-33 Available audio ports menu
8)
Select the head set for which the call destination is to be set. The menu
for the selected headset will be displayed.
for the selected headset will be displayed.
Figure 6-34 Selected port menu for calls
9)
Select ‘KEY’ from the menu. The audio destination menu will be displayed.
Figure 6-35 Port call menu
10)
Use the setup/enter encoder to scroll through the available ports and
select the required destination port. It is possible to select the source port
as the call destination to create an audio loopback system. This may be
used for audio testing purposes.
select the required destination port. It is possible to select the source port
as the call destination to create an audio loopback system. This may be
used for audio testing purposes.
11)
The port destination can be cleared by repeating the process and selecting
the ‘NONE’ entry.
the ‘NONE’ entry.
6.15
Configuring a wired partyline
Before enabling a partyline from the Base station’s front panel the type of
partyline must be set on the Base station so that it can set the proper
termination, gain level, and call signaling for that system.
partyline must be set on the Base station so that it can set the proper
termination, gain level, and call signaling for that system.