Digital Monitoring Products Inc PC0132 Manuel D’Utilisation

A custom dealer logo and dealer information may be added to the Main Screen of the 

keypad prior to being connected to the panel. Use the following steps:

1. Connect the 12 Volt DC power supply to the keypad.

2. Power up the keypad and the keypad screen displays SYSTEM BUSY.

3. Press CMD to display ENTER CODE:.

4. Enter 3577 and press CMD to access the Installer Menu.

5. Press KPD  OPT to access keypad options menu.

6. Press CMD until DEALER LOGO  ADD  DELETE displays.

7. Insert Micro SD card with dealer logo into the slot on the right side of the keypad.

8. Press ADD. Keypad displays ADDING LOGO  SURE?  YES  NO.

9. Press YES to load dealer logo. Keypad displays ADDING LOGO.

10.  When the dealer logo is successfully loaded the keypad displays 

ADDING LOGO COMPLETE.

11. Press CMD to exit Dealer Logo menu.

12. Keypad displays DEALER INFO  ADD  DELETE.

13. Press ADD. Keypad displays ADDING INFO  SURE?  YES  NO

14. Press YES to load dealer information. Keypad displays ADDING INFO.

15.  When the dealer information is successfully loaded the keypad displays 

ADDING INFO COMPLETE.

16. Press CMD to exit to Dealer Info menu.

17. Press Stop to exit Installer Menu.

18. Press in and release to eject the micro SD card

Note: If for any reason the logo or information fails to load the keypad displays 

BAD FORMAT. Contact DMP Marketing at 1-800-641-4282 or privatelabel@dmp.com for 

information about acquiring a logo.

The keypads allow users to present a proximity credential to the built-in proximity 

reader. Users can also manually enter their user code into the keypad. The keypad 

verifies the user code and its authority with the panel. Additionally, the 9863 keypad 

activates the on-board Form C relay releasing a door strike or magnetic lock. To 

provide added flexibility, the 9863 Keypads allow connection of an external Wiegand 

output compatible reader.

The 9862 and 9863 keypads provide a built-in proximity card reader designed to read 

DMP/HID 1300 Series proximity credentials.

To accept Wiegand data input from other external card readers, connect a 

12 VDC external reader to the 9863 keypad. Connect the Red and Black power wires 

from the reader to the Black/White and Black power wires from the keypad. Connect 

the Reader (Data 1) wire to the White wire on the 5-wire keypad harness. Connect 

the Reader (Data 0) wire to the Green/White wire on the 5-wire keypad harness. 

See Figure 9.