Digital Monitoring Products Inc PC0163 Manuel D’Utilisation
CellComSL
Series Universal Communicator Installation and Programming Guide
Digital Monitoring Products
29
Appendix
18.5 Cross Zoning
Caution must be taken when cross zoning devices to ensure that the Cross Zone Time is long enough to allow a
trip of both zones before it expires. A Cross Zone Time that is too short may allow a trip of the zones and only a
zone fault report be sent to the Central Station.
When a Cross Zoned zone trips, a FAULT report is sent to the SCS-1R or SCS-VR Receivers. When two Cross Zoned
When a Cross Zoned zone trips, a FAULT report is sent to the SCS-1R or SCS-VR Receivers. When two Cross Zoned
zones trip within the Cross Zone Time, both zones send ALARM signals to the receiver. For example, if zones 1
and 2 are Cross Zoned zones, and only zone 1 trips, a FAULT report is sent to the receiver for zone 1. If zone 1
trips and zone 2 trips within the Cross Zone Time, an ALARM report is sent to the receiver for zone 1 and zone 2.
Note: To operate correctly, all cross-zone zones need to be programmed as the same zone type.
Note: To operate correctly, all cross-zone zones need to be programmed as the same zone type.
18.6 Z-Wave Information
The CellComSLCZ is a security enabled Z-Wave product and is designed to be used as a primary controller.
The XFER feature allows an existing 3rd party network to be transferred into the CellComSLCZ.
The CellComSLCZ can support Z-Wave products from different vendors and product categories. It is
The XFER feature allows an existing 3rd party network to be transferred into the CellComSLCZ.
The CellComSLCZ can support Z-Wave products from different vendors and product categories. It is
recommended to use devices listed on the buy.dmp.com site for best performance.
Z-Wave terminology:
• Inclusion is the process of adding a device to the Z-Wave network. The new device is ‘included’ into the
Z-Wave terminology:
• Inclusion is the process of adding a device to the Z-Wave network. The new device is ‘included’ into the
Z-Wave network.
• Exclusion is the process of removing a device from the Z-Wave network. The new device is ‘excluded’ from
the Z-Wave network.
• Replication is the process of copying network information to another device (typically a Z-Wave controller) in
the Z-Wave network.
18.7 Zone 4 Bell Cadence Information
The CellComSL Series evaluates the first 3.5 seconds of bell cadence timing to detect the type of alarm sent.
Bell cadence types are:
Bell cadence types are:
BELL CADENCE
ZONE NUMBER
TYPE OF MESSAGE
Steady
ZONE 4
BURGLARY
Pulse or Temporal 3
ZONE 5
FIRE
Temporal 4
ZONE 6
EMERGENCY OR
CARBON MONOXIDE
Figure 16: Zone 4 Bell Cadence Information
Steady
Pulse
Temporal 3
Temporal 4
1.0 sec.
1.0 sec.
1.0 sec.
1.0 sec.
1.0 sec.
.5 sec.
.5 sec.
.5 sec.
1.5 sec.
.5 sec.
.5 sec.
.5 sec.
.5 sec.
3.5 sec.
Each .1 sec. On
5.0 sec.
On
Off
On
Off
On
Off
On
Off
Each .1 sec. Off
Each .1 sec. On
Each .1 sec. Off