Williams Sound DLT300 Manuel D’Utilisation
DLT 300 3.0 Digital Transceiver and DLR 360 3.0 Digital Receiver
6
QUICK GROUP CHANGE / SETUP BUTTONS
· Press and hold
and
together for 3 seconds to enter or exit setup menu
· Press and hold
button for 3 seconds to enter quick group change mode. The GRP light will flash. Then use
or
to change groups. To exit, push
again or just wait until the unit times out.
· Use these buttons to select channels in simultaneous interpretation mode
MICROPHONE LEVEL ADJUSTMENT
· Hold the
button for two seconds to enter mic level adjustment. For level adjustment use
or
VOLUME CONTROL / SELECT BUTTON
· Control / Volume
· Use to navigate selections in setup menu.
· Access and adjust tone control (0-53)
· Use to navigate selections in setup menu.
· Access and adjust tone control (0-53)
TALK BUTTON
· Press button momentarily once to activate the microphone. Press button once more to turn off the microphone
· Press and hold the button for approximately 2 seconds to mute other DLT 300 3.0 Guest units. Only the M1 and M2 have this
· Press and hold the button for approximately 2 seconds to mute other DLT 300 3.0 Guest units. Only the M1 and M2 have this
function.
([TALK] LED will blink on all units when in mute mode).
Battery Charging – DLT 300 3.0
1. This Product uses an internal rechargeable Lithium Polymer battery.
2. Use the 30 Pin connector, located on the bottom of DLT 300 3.0 to charge the battery. Full charging time is approximately
5 hours. The Red LED flashes while charging. The Green LED will be on steady when the battery is charged.
3. Battery Maintenance - Charge the battery at room temperature.