Williams Sound DLT300 Manuel D’Utilisation
DLT 300 3.0 Digital Transceiver and DLR 360 3.0 Digital Receiver
7
DLr 360 3.0 controls and connectors
A539
RED LED
GREEN LED
CH/GROUP
CHANGE
VOLUME
ADJUST
POWER
HEADPHONE
JACK
SPEAKER
BATTERY
STRENGTH
BATTERY TYPE
SWITCH
LANYARD
SLOT
30-PIN
DOCKING/
CHARGING
CONNECTOR
STRENGTH DLT#1
STRENGTH DLT#2
NUMERIC DISPLAY
NUMERIC TYPE
ANTENNA
SYMBOL
BATTERY
COMPARTMENT
A539
RED LED
GREEN LED
CH/GROUP
CHANGE
VOLUME
ADJUST
POWER
HEADPHONE
JACK
SPEAKER
BATTERY
STRENGTH
BATTERY TYPE
SWITCH
LANYARD
SLOT
30-PIN
DOCKING/
CHARGING
CONNECTOR
STRENGTH DLT#1
STRENGTH DLT#2
NUMERIC DISPLAY
NUMERIC TYPE
ANTENNA
SYMBOL
BATTERY
COMPARTMENT
DLr 360 3.0 Operation
1. Insert 2 AAA batteries into the DLR. Observe correct polarity. You can use either Alkaline or NiMH, but make sure the battery
switch is in the NiMH position to charge NiMH batteries. If Alkaline batteries are used, put the battery switch in the ALK position.
2. Power on/off by holding the power button
2. Power on/off by holding the power button
for 3 seconds.
3. In 1-way mode, the DLR will seek active DLTs; press channel button up or down to seek next active DLT. In 2-way mode,
group must be selected.
4. The Antenna Symbol will flash, and there will be no Signal Strength Bars, if not synchronized with a DLT.
5. If the units are synchronized, briefly push the power button
4. The Antenna Symbol will flash, and there will be no Signal Strength Bars, if not synchronized with a DLT.
5. If the units are synchronized, briefly push the power button
to show group assigned (0 to 99).
6. To change group, hold the
and
buttons for 3 seconds until “GROUP” is flashing.
7. Use
or
buttons to select group number.
8. Hold
and
buttons for 3 seconds again to save the group number.
9. To change volume level press
or
buttons, display will show 00 through 30.
10. User can listen using the speaker on the back of the DLR or by plugging in stereo or mono earphones into the jack (which
defeats the speaker operation).
11. Low battery indicator will show as a blinking battery symbol with no bars inside it.
12. The DLR will automatically power down after 5 minutes if not synchronized with a DLT.
11. Low battery indicator will show as a blinking battery symbol with no bars inside it.
12. The DLR will automatically power down after 5 minutes if not synchronized with a DLT.
Battery Charging – DLR 360 3.0
1. This Product can charge AAA NiMH batteries in the battery compartment when the battery switch is in the NiMH position.
2. Use the 30 Pin connector, located on the bottom of DLT 300 3.0 to charge the battery. Full charging time is approximately
2. Use the 30 Pin connector, located on the bottom of DLT 300 3.0 to charge the battery. Full charging time is approximately
5 hours. The Red LED flashes while charging. The Green LED will be on steady when the battery is charged.
3. Battery Maintenance - Charge the battery at room temperature.