3Com Corporation WL306 Manuel D’Utilisation
10
C
HAPTER
2: I
NSTALLING
THE
A
CCESS
P
OINT
Connecting to an
Ethernet Network
Ethernet Network
Use a standard Ethernet cable to connect the access point to an Ethernet network,
as shown below.
as shown below.
Checking the LEDs
To avoid damaging other components connected to the network, make sure
that the Ethernet cable connected to the LAN port is plugged into the To
Hub/Switch port on the power supply (not the To Access Point port).
that the Ethernet cable connected to the LAN port is plugged into the To
Hub/Switch port on the power supply (not the To Access Point port).
RE
SE
T
TO
PO
W
ER
S
UP
PLY
ETH
ERN
ET
WIR
EL
ESS
POW
ER
TO
A
CC
ES
S P
OINT
TO
H
UB
/S
WI
TC
H
Ethe
rnet
LED
Description
Power
■
On—Access point has power.
■
Off—Access point is not receiving power.
Wireless
■
Blinking—The access point is operating. The blink speed ranges from
approximately once every 2.5 seconds to approximately 10 times per
second, depending on the signal strength and transmission speed.
approximately once every 2.5 seconds to approximately 10 times per
second, depending on the signal strength and transmission speed.
■
Off—The access point is not receiving power.
Ethernet
■
Blinking—Wired LAN traffic is detected. Faster blinking indicates
heavier traffic.
heavier traffic.
■
Off—There is no wired LAN connection or the access point is not
receiving power.
receiving power.