3M Company OPTICOMGPS1 Manuel D’Utilisation
Vehicle Equipment Installation Instructions
17
10. Place the control unit into the mounting bracket.
Use the two 1/4-inch acorn nuts and lock washers
to secure the control unit to the bracket. See
Figure 5-6. The control unit must be level within
15 degrees to allow the internal compass to
function.
to secure the control unit to the bracket. See
Figure 5-6. The control unit must be level within
15 degrees to allow the internal compass to
function.
Figure 5-6. Vehicle Control Unit Installation
1. Mounting bracket
3. Acorn nut (2)
2. Lock washer (2)
4. Vehicle control unit
11. Route the wires of the vehicle interface harness to
the appropriate connection points. Table 5-3
shows the connector socket pin number, wire
color, and function for each wire. Figure 5-7
shows the socket view of the harness connector.
All wires may not be used in all installations.
shows the connector socket pin number, wire
color, and function for each wire. Figure 5-7
shows the socket view of the harness connector.
All wires may not be used in all installations.
Figure 5-7. Interface Harness Connector Socket
Table 5-3. Interface Harness Connector Pin Index
Pin
Wire Color
Function
1
White/Yellow
J1708 (+) (future use)
2
Blue
Lightbar sense or
Ignition switch
Ignition switch
3
Brown
Low priority
4
Gray
Spare Input (future use)
6
White
Disable sense
7
Green
Right turn sense
8
Yellow
Left turn sense
9
Black
Ground
10
Red
+12 VDC
13
White/Orange
GPS TXD (-)
14
White/Brown
GPS TXD (+)
15
White/Blue
J1708 (-) (future use)