Computime Limited AAHZT3A Manuel D’Utilisation
July 5, 2012
Page 26 of 49
66 8003 002-7
4.5.1.2 Joining the in-room devices to the thermostat controller
The next step is to join the in-room devices, e.g. thermostats, motion sensors and locks (or RF door switches,
if this is applicable).
if this is applicable).
Note:
When the thermostat controller is applicable, the thermostat has an endnode firmware. The thermostat controller
has either a router firmware or a coordinator firmware, depending on scenario. The coordinator firmware is for offline
scenarios when there is no connection to the server; see Appendix C for details about setting up the in-room network in
that case.
scenarios when there is no connection to the server; see Appendix C for details about setting up the in-room network in
that case.
1.
Plug the service cable into the thermostat controller.
2.
Click the
Permit Join
button in the
Configure device
section (
Thermostat
tab) of Orion Service;
see picture in 4.5.1.1.
Note:
The thermostat controller will remain open for 15 minutes or until a forbid join command is received.
3.
Once the thermostat controller has
been opened for joining, plug the
service cable into the applicable
in-room device. Choose the
been opened for joining, plug the
service cable into the applicable
in-room device. Choose the
Motion
sensor
tab in the
Configure device
section of Orion Service; click the
Discovery
button.
4.
Wait a few seconds and then click the
Check status
button. If the device has
joined successfully, the message
‘Device is online’ is shown. If that
message is not displayed, wait a few
more seconds and check the status
again. If the device is still offline,
repeat the discovery process.
‘Device is online’ is shown. If that
message is not displayed, wait a few
more seconds and check the status
again. If the device is still offline,
repeat the discovery process.
5.
Join the lock and use an Enable EMI
events card in it; details are found in
the section Enabling EMI events via
card in Appendix C.
events card in it; details are found in
the section Enabling EMI events via
card in Appendix C.
6.
If an RF door switch is applicable
instead of a lock, repeat steps 3-5
with the RF door switch; in step 4,
use the
instead of a lock, repeat steps 3-5
with the RF door switch; in step 4,
use the
Door switch
tab.
7.
Click the
Forbid join
button under
the
Thermostat
tab in the
Configure
device
section of Orion Service; see
picture in 4.5.1.1.
8.
Test the in-room devices; details are
found in section 4.6.
found in section 4.6.
Figure 21