Computime Limited AAHZT3A ユーザーズマニュアル

ページ / 50
 
July 5, 2012  
  
 
                  
       
                                
Page 26 of 49   
                                         66 8003 002-7 
 
 
4.5.1.2 Joining the in-room devices to the thermostat controller 
The next step is to join the in-room devices, e.g. thermostats, motion sensors and locks (or RF door switches,  
if this is applicable).  
 
Note:
 
When the thermostat controller is applicable, the thermostat has an endnode firmware. The thermostat controller  
has either a router firmware or a coordinator firmware, depending on scenario. The coordinator firmware is for offline 
scenarios when there is no connection to the server; see Appendix C for details about setting up the in-room network in  
that case.  
 
1.
 
Plug the service cable into the thermostat controller.   
2.
 
Click the 
Permit Join
 button in the 
Configure device
 section (
Thermostat
 tab) of Orion Service;  
see picture in 4.5.1.1.   
Note:
 The thermostat controller will remain open for 15 minutes or until a forbid join command is received. 
3.
 
Once the thermostat controller has  
been opened for joining, plug the 
service cable into the applicable  
in-room device. Choose the 
Motion 
sensor
 tab in the 
Configure device
 
section of Orion Service; click the
 
Discovery
 button. 
4.
 
Wait a few seconds and then click the 
Check status
 button. If the device has 
joined successfully, the message 
‘Device is online’ is shown. If that 
message is not displayed, wait a few 
more seconds and check the status 
again. If the device is still offline,  
repeat the discovery process.   
5.
 
Join the lock and use an Enable EMI 
events
 card in it; details are found in  
the section Enabling EMI events via 
card
 in Appendix C.  
6.
 
If an RF door switch is applicable 
instead of a lock, repeat steps 3-5  
with the RF door switch; in step 4,  
use the 
Door switch
 tab.  
7.
 
Click the 
Forbid join
 button under  
the 
Thermostat
 tab in the 
Configure 
device
 section of Orion Service; see 
picture in 4.5.1.1.   
8.
 
Test the in-room devices; details are 
found in section 4.6.  
  
 
                                                                                             Figure 21