Checkpoint Systems Inc. EVOLVES10 Manuel D’Utilisation
Chapter 2 – SocketModem (MT5600SMI & MT5656SMI)
Multi-Tech Systems, Inc. Universal Socket Hardware Guide for Developers (S000342D)
63
Recommended Parts
Disclaimer: Multi-Tech Systems makes no warranty claims for vendor product recommendations listed
below. Other vendor products may or may not operate satisfactorily. Multi-Tech System’s recommended
vendor products only indicate that the product has been tested in controlled conditions and were found to
perform satisfactorily.
below. Other vendor products may or may not operate satisfactorily. Multi-Tech System’s recommended
vendor products only indicate that the product has been tested in controlled conditions and were found to
perform satisfactorily.
Surface mount ferrites are used on T&R (Tip and Ring) to mitigate emission levels out the RJ-11 cable. 220pF
capacitors are also used on T&R to reduce the common mode emissions that may be present in certain systems.
The ferrite and capacitors also aid in reducing the effects of transients that may be present on the line.
capacitors are also used on T&R to reduce the common mode emissions that may be present in certain systems.
The ferrite and capacitors also aid in reducing the effects of transients that may be present on the line.
Recommended Ferrite (SMT)
Manufacturer – Associated Component Technology (ACT) – Part # - YCB-1206
Manufacturer – Murata Erie – Part # - BLM31AJ601SN1
Manufacturer – Murata Erie – Part # - BLM31AJ601SN1
Recommended Ferrite (Thru-Hole)
Manufacturer – Associated Component Technology (ACT) – Part # - WB2-2.OT
Recommended Capacitor
Manufacturer – NOVACAP – Part # - ES2211NKES502NXT
Manufacturer – Murata Erie – Part # - GA355DR7GC221KY02L (Surface mount device)
Manufacturer – Murata Erie – Part # - GA355DR7GC221KY02L (Surface mount device)
Part # - DE0807B221K-KH (Thru-hole device)
Manufacturer – Ever Grace Electronic Industrials -- Part # - YP221K2EA7PS
Note:
The capacitors used on T&R must have the Y2 safety rating.
Recommended Connector
Manufacturer – Stewart – Part # - SS-6446-NF-A431
Recommended Poly Switch Thermal Fuse (can be reset)
Manufacturer – RayChem – Part # - TS600-170
Note:
This fuse or its equivalent is required to meet UL60950 for protection against over-voltage from power
line crosses.
Telecom
The RJ-11 connector must meet FCC Part 68 requirements. Refer to FCC Part 68 section 68.500 subpart F
for connector specifications. A self-healing fuse is used in series with line to help prevent damage to the
DAA circuit. This fuse is needed for FCC Part 68 compliance.
for connector specifications. A self-healing fuse is used in series with line to help prevent damage to the
DAA circuit. This fuse is needed for FCC Part 68 compliance.
Common Mode Choke
Manufacturer – TDK – Part # - ZJYS51R5-2PT
Recommended Sidactor
Manufacturer – Teccor Electronics – Part # - P#3100SA
Manufacturer – ST Microelectronics -- Part 1 – SMP100LC-270
Manufacturer – ST Microelectronics -- Part 1 – SMP100LC-270
Recommended Transceiver
Manufacturer – Analog Devices – Part # - ADM207EAR
Dip Connector for the MT5600SMI-P92
Manufacturer – Specialty Electronics (www.connectorsolutions.com)
4-Pin 2.0mm SIP Socket (2 Each)
10-Pin 2.0mm SIP Socket (2 Each)