Mindray DS USA Inc. WT0707-00000 Manuel D’Utilisation

3. Choose the Select button. The selected parameter is assigned its new unit priority 

position and will be shown in the box on the right of the selected unit priority.

4. Repeat steps 2-3 until the parameters are in the desired order. 

5. Select the Done button. All priority changes in the Unit Priorities tab have now been 

confirmed. The changes that were made will only be applied to newly admitted patients 
and will not affect patients currently being monitored. 

9.13.2.1

Setting the Waveform System Defaults 

Select the Wave Defaults sidebar button to select the system default patient tile waveforms. 

1. Select the Wave Defaults sidebar button in the Unit Priorities tab. The Wave 

Defaults dialog box (shown in FIGURE 9-37) is displayed.

FIGURE 9-37 Wave Defaults Dialog Box

1. Select the Waveform 1 button until the desired ECG waveform is displayed.

The settings available for the ECG waveform include ECG I through V6. The factory 
default setting is ECG II.

2. Select the Waveform 2 button until the desired ECG waveform is displayed.

The settings available for the ECG waveform include ECG I through V6, IBP1-IBP4, Resp, 
Pleth, CO2, O2, Agent, and OFF. The factory default setting is OFF.

3. Accept or reject the selections made in the dialog box.

• Select the Done button to accept the selections. 

• Select the Cancel button to discard the selections, close the dialog box and return to 

the Unit Priorities tab.

9.13.3

Sidebar Buttons 

The following sidebar buttons are used to expand the functionality of this tab.

Wave Defaults 

This sidebar button was previously described on page 9-48. 

Normal Screen

Select the Normal Screen sidebar button to return the display to the full screen mode, and 
close all tabs, message boxes, and dialog boxes.