Wyse Technology WT3320 Manuel D’Utilisation
30
Cable Firmware Upgrades
The following section describes the cable method of firmware download. The cable
method for all terminals is parallel download, using a Laplink
method for all terminals is parallel download, using a Laplink
cable and the
MS-DOS xfer.exe program.
Setup
The following equipment may be needed, depending on the download procedure
used:
• IBM-compatible PC with a CD-ROM drive and a parallel/serial port.
• Terminal firmware upgrade diskette or CD.
• LapLink or equivalent parallel port communications cable (used only if parallel
used:
• IBM-compatible PC with a CD-ROM drive and a parallel/serial port.
• Terminal firmware upgrade diskette or CD.
• LapLink or equivalent parallel port communications cable (used only if parallel
port is used for downloading).
To validate an image file before downloading, type check <filename.ext> at the
DOS command line, then press Enter. The check utility verifies the image file.
DOS command line, then press Enter. The check utility verifies the image file.
Note
For convenience, drive D:\ is used for the CD drive. You
should substitute the appropriate drive letter for your
PC.
should substitute the appropriate drive letter for your
PC.