Wyse Technology WT3320 Manuel D’Utilisation

3. Power-up the terminal to initiate the download.

The Firmware Upgrade dialog box appears, showing that the download is in 
progress. When the download is complete, disconnect the parallel cable. The 
Setup Wizard will appear.

If the download dialog box remains on the screen 
longer than 1 minute, press the Enter key. A prompt to 
repeat or quit the operation appears. If the download 
fails, quit the procedure, check all cables and 
connections, then repeat from Step 2.

Use the following instructions to perform an auto download:

1. Log on to the root of the drive where the installation batch file resides (usually 

D:).

2. Type install at the DOS prompt, then press Enter. The Download Utility dialog 

box appears and the install program prompts you through the download 
procedures.

3. When you are finished with your download, disconnect the LapLink cable and 

reconnect the peripheral cables.

4. Power-up the terminal and reconfigure its communications and options settings.

5. Check the About dialog box to verify the download revision.