Rockwell Collins Inc. 8222210 Manuel D’Utilisation

The access point supports simultaneous radio operation using a 2.4-GHz 802.11g radio and a 5-GHz 
802.11a radio. Each radio uses dual-diversity integrated antennas.

The 5-GHz radio incorporates an Unlicensed National Information Infrastructure (UNII) radio 
transceiver operating in the UNII 5-GHz frequency bands. The 802.11g radio is called Radio0 and the 
802.11a radio is called Radio1.

In 

Cisco IOS Release 12.3(4)JA and later

, the access point radios are disabled by default, and there is no 

default SSID. You must create an SSID and enable the radios before the access point allows wireless 
associations from other devices. 

 lists the supported access point antennas.

The auto-sensing Ethernet port (see 

) accepts an RJ-45 connector, linking the access point to 

your 10BASE-T or 100BASE-T Ethernet LAN. The access point can receive power through the Ethernet 
cable from a power injector, switch, or power patch panel. The Ethernet MAC address is printed on the 
label on the back of the access point (refer to the 

). 

The serial console port provides access to the access point’s command-line interface (CLI) using a 
terminal emulator program. The port is located on the end of the unit (see 

). Use an RJ-45 to 

DB-9 serial cable to connect your computer’s COM port to the access point’s serial console port. (Refer 
to 

 for a description of the console port pinouts.) Assign the 

following port settings to a terminal emulator to open the management system pages: 9600 baud, 8 data 
bits, No parity, 1 stop bit, and no flow control.

Diversity ceiling omnidirectional

2

Articulated omnidirectional

3.5

Articulated dipole

2.2

Diversity omnidirectional

4.5

Ceiling omnidirectional

5.2

Omnidirectional

6

Wall patch directional

6

Diversity patch directional

7

Mast mount omnidirectional

5.2

Patch directional

9.5

Diversity pillar omnidirectional

5.2

Diversity patch directional

6.5

Patch directional

9

Yagi directional

10