Rockwell Collins Inc. 8222210 Manuel D’Utilisation
D r a f t 1 A - C I S C O C O N F I D E N T I A L
3-8
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
OL-7293-01
Chapter 3 Configuring the Access Point for the First Time
Assigning Basic Settings
Default Settings on the Express Setup Page
lists the default settings for the settings on the Express Setup page.
Enabling the Radio Interfaces
In
Cisco IOS Release 12.3(4)JA or later
, the access point radios are disabled by default, and there is no
default SSID. You must create an SSID and enable the radios before the access point will allow wireless
associations from other devices. These changes to the default configuration improve the security of
newly installed access points. Refer to the
associations from other devices. These changes to the default configuration improve the security of
newly installed access points. Refer to the
instructions on configuring the SSID.
To enable the radio interfaces, follow these instructions:
Step 1
Use your web-browser to access your access point.
Step 2
When the Summary Status page displays, click Network Interfaces > Radio0-802.11b or Network
Interfaces > Radio0-802.11g and the radio status page displays.
Interfaces > Radio0-802.11g and the radio status page displays.
Step 3
Click Settings and the radio settings page displays.
Step 4
Click Enable in the Enable Radio field.
Step 5
Click Apply.
Step 6
Click Radio1-802.11A and the radio status page displays.
Step 7
Repeat Steps 3 to 5.
Step 8
Close your web-browser.
Table 3-1
Default Settings on the Express Setup Page
Setting
Default
System Name
ap
Configuration Server Protocol
DHCP
IP Address
Assigned by DHCP
Note
The access point does not have a default IP address.
IP Subnet Mask
Assigned by DHCP
Default Gateway
Assigned by DHCP
Role in Radio Network
Access point (root)
Web Server
Standard (HTTP)
SNMP Community
defaultCommunity
Optimize Radio Network for
Throughput
Aironet Extensions
Enable