Sony Corporation DWTB01N Manuel D’Utilisation

13

Using wireless remote control, this function can be 
controlled from the receiver and other devices.

The POWER switch can be locked to prevent the 
transmitter from being accidentally turned off or on.
Even when the POWER switch is locked, all parts of the 
transmitter other than the POWER switch remain 
functional.

UNLOCK: The POWER switch is not locked.
LOCK: The POWER switch is locked.
When LOCK is selected, the POWER switch lock icon 
appears in the display.

Using wireless remote control, this function can be 
controlled from the receiver and other devices.

This function must be set to allow the wireless remote 
control function to be used between the transmitter and 
receiver.

OFF: Stops the wireless remote control function.
ON: Starts the wireless remote control function with the 
previously paired receiver.
PAIRING: Executes a new pairing.

For details, see “Pairing with a receiver” on page 7.

 

If “RESTRICTED BY GP/CH SETTING” appears on the 
RF REMOTE screen, the wireless remote control function 
cannot be used. To use the wireless remote control 
function, select a different transmission channel.

Ten levels of brightness can be selected for the organic 
light-emitting diode display.
The selectable settings are the following:
(Dark) 1  2  3  4  5  6  7  8  9  10 (Bright)

The organic light-emitting diode display can be set to dim 
or turn off after a certain amount of time.

AUTO OFF: The display turns off after 30 seconds. The 
display goes on again when you press the SET, +, or – 
button.
AUTO DIMMER: The display dims after 30 seconds. The 
display becomes bright again when you press the SET, +, 
or – button.
ALWAYS ON: The display stays on at the brightness 
level set with the BRIGHTNESS function.

All parameter settings can be returned to their factory 
settings.
Holding down the SET button until a message appears 
asking for confirmation. Press the + or – button repeatedly 
to select YES, and then press the SET button to enter. The 
transmitter parameters are reset to their factory settings.

 

• The setting for this function cannot be changed during 

actual signal transmission. To change the setting, turn 
off the power first. Then while holding down the SET 
button, turn the power on. Then change the setting after 
the signal transmission has stopped.

• To start signal transmission with the factory parameter 

settings, turn off the power and then turn it on again.

The version of the transmitter software can be displayed.