Sony Corporation UTXM03A Manuel D’Utilisation

Tuner Settings

21

The basic menu operation is the same in simple mode and 
extended mode.

Press the + or – button to display the function to be 
set.

Press and hold the SET button until the setting starts 
flashing.

Press the + or – button to change the setting.

Press the SET button to enter the setting.

If no operation is performed for five seconds, the 
backlight will turn off. Pressing any button will turn the 
backlight on again.

For details about the channel groups and channels that can 
be selected, refer to the “Frequency List” on the 
CD-ROM.

Use the + or – button to display the GP/CH menu.

Press and hold the SET button for one second or 
longer.

The channel group display starts flashing. 

Use the + or – button to select the desired group 
name, then press the SET button.

The channel group is set, and the channel number 
display starts flashing.

Use the + or – button to select the desired channel 
number, then press the SET button.

The displays stops flashing and the desired channel is 
set.

• If there is no user input within ten seconds after the 

channel group display or channel number display starts 
flashing, the displayed setting that is flashing is saved. 
The same applies when setting other parameters.

• The frequency indicator changes in response to the 

channel number.

• The tuner continues to receive, even when setting the 

receive channel.

• Do not remove the batteries while setting the receive 

channel. If they are removed, re-insert them and repeat 
the procedure from the beginning.

• Make sure that the same channel is set on the 

transmitter and tuner within the same system.

Procedure for portable diversity tuner (URX-P03)
You can search for available channels within the 
specified channel group. 
Before performing this procedure, select the channel 
group.

Use the + or – button to display the CLR SCAN 
menu.

Press and hold the SET button for one second or 
longer.

Press and hold until the channel group and “+” 
display starts flashing.

Function name

Setting