Honeywell International Inc. 9PGTPL-100A Manuel D’Utilisation

Page 1019

1 Mar 2006

TPL-100A Processor / Part No. 940-0530-001

Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.

Table 1008.   Directional Antenna Test Procedure (cont)

(1) Remove the adapter cable (part number 965RFTS-201) from the hard case and 

connect it to the Site Master S331 test port.

NOTE: All connections should be finger tight. DO NOT OVER TIGHTEN OR USE 

PLIERS.

(2) Select the SMA jack to "N" Jack adapter (part number NS010, see Figure 1) from the 

hard case and connect the SMA plug end of the adapter cable.

(3) Perform a measurement calibration by pressing the START CAL on to keyboard.

(4) Select the desired location to store the calibration, CAL A or CAL B, by using the 

Up/Down Arrow

key. Place the > symbol adjacent to the desired location and press the 

ENTER key.