Authinx Inc. 24110T Manuel D’Utilisation

13

12

The SLEEP button enables the remote to turn off your
TV after a period of 1 to 99 minutes as shown below.
The remote must be in TV mode to set a Sleep Timer.
This feature works even if your TV does not have a
sleep feature.

1. Press and release the TV device button.
2. Press and hold the SLEEP button until the red

indicator remains lit (about 2-3 seconds).

3. Release the SLEEP button.
4. Press and release the numeric buttons (01-99) for

the time required. The red indicator will blink off to
indicate button press acceptance.

5. TV Sleep Timer is set.
6. Leave the Remote pointing towards the TV with an

To cancel the Sleep Timer, press and hold the SLEEP
button until the red indicator blinks, or press and
release the ON-OFF button in TV mode.

• Press the mode button of the product you want to

control.

• Program the remote with a new code.
• Install new batteries. (You might have to reprogram

your remote after installing new batteries.)

• Remote may not be compatible with your product.

• Program remote with a new code.
• Remote may not be able to operate all features of

your product or button names might be different
than your product.

• Remote did not accept the code.
• Try to program the code again or try a different

code.

Enclosed with this remote is a sticker on which you
should write the codes for each device you programmed.
Apply the sticker to the back of the remote or
somewhere convenient for future reference.

Also on the sticker is our website address which, should
you lose your codes or programming instructions, you
can find available on our website:
www.jascoproducts.com

The 24110 comes with a convenient base/stand that you
can place the remote in when you’re not using it. The
base/stand also has a Find/Page feature, which lets you
quickly find the remote from up to 20 feet from the base,
if you’ve misplaced it. You simply press the Page key
on the base and the remote sounds with a tone, making
it easy to locate.

PAGE